An already well-established spray foam insulation company purchased a CM1500 HP to add wall spray, attic and dense pack insulation to their services.

We insulated an attic with Owens Corning fiberglass. Then we erected a temporary wall and trained on cellulose wall spray. Using the “dry” method, we were able to spray cellulose into the wall with proper stabilization and far less water than most.

We also created a promotional video for their facebook page. This company promotes their business through facebook. Within three days, the video had nearly 100 shares and well over 5,000 views. Pretty viral for an insulation company!

We travelled to Aberdeen, South Carolina to meet with an approved Energy Doctor vendor: Custom Services. They purchased a CM700 two years ago and their business built up to the place where they needed more production.

They purchased a CM2400 with an upgraded airlock for more production. With that, they added our internal wetting system and a generator with a slider.

We created a promotional video for their company.

Mr. Reedie says: “Barry runs a great operation. Very knowledgeable, responsive, honest and professional!”

This article introduces the steps and materials involved in dense packing cellulose into an unfinished wall cavity. This project was filmed at a house retrofit in Flint, Michigan. This rebuild will showcase the highest in energy-efficiency standards. This is a collaborative project between Mott University and the Department of Energy.
More

This on-site training involved more than shown in the video below. In November 2011, we flew to Phoenix, AZ to train Orangutan Home Services in properly adding additional attic insulation.

This rather new home needed another 6” of insulation. On inspection of the attic, we found some spots where that the existing blown material was being blown away from the top plate from the soffit vents. We installed DuroVents and used fiberglass batt to stop air flow from blowing loose material away from the top plate. More

Joe Kruser with A+ Insulation in Janesville is already an accomplished spray foam insulator. He is expanding his insulation offerings to include cellulose wall spray. He owns a CM2400 and is manually recycling the material. More